ktm24
New Member
Posts: 1
|
Post by ktm24 on Dec 1, 2021 11:13:20 GMT -6
Hey, new member here hoping for some help from the pro’s. I’m currently rebuilding my keihin carbs due to a bad seat causing fuel dump. After inspection I found the seat surface is worn so far a new needle will not seal. Iv tried cleaning and creating a new surface for the seat to rest on but it is just too far worn. The seat must be replaced and since it’s a press in Style I cannot find a replacement, does any have know of a universal style that will fit, I’ll have one machined as a last resort but was hoping to buy one. Thanks
|
|
rev79
New Member
Posts: 1
|
Post by rev79 on Apr 27, 2022 19:42:44 GMT -6
Hey, new member here hoping for some help from the pro’s. I’m currently rebuilding my keihin carbs due to a bad seat causing fuel dump. After inspection I found the seat surface is worn so far a new needle will not seal. Iv tried cleaning and creating a new surface for the seat to rest on but it is just too far worn. The seat must be replaced and since it’s a press in Style I cannot find a replacement, does any have know of a universal style that will fit, I’ll have one machined as a last resort but was hoping to buy one. Thanks Did you ever get anywhere with this? I'm having the same type of issue When I checked float hight at 17mm it leaks but if I set it at 21mm it seals
|
|