|
Post by slayer13x on Aug 17, 2016 21:54:59 GMT -6
I have my floats set at 17mm 135 main jets And the idle screws set at 2 1/2 turns When ever I try and run the bike it will either run for a little bit but you can see gas running out the carb and see the manifold burning it off or it will start to rev up to 4000 rpms until I hit the kill switch. I'm running a set of eBay pod filters and have no mufflers on right now. Any ideas why I can't get it to idle correctly or if the main jets are too big?
|
|
|
Post by eaglerider on Aug 18, 2016 3:29:55 GMT -6
Gas running out of carbs are an indication that the float needles are not shutting off the gas....perhaps floats just a tad too high.
|
|
|
Post by slayer13x on Aug 18, 2016 15:31:17 GMT -6
Ok. So correct me if I'm wrong but that would mean I would need to go up to 18 or 19 mm correct?
|
|