|
Post by bobberboiiiii on Feb 1, 2021 21:13:15 GMT -6
I know recently there was a simplified wiring diagram posted but still have a few questions about that. It’s listed as the En450 harness simplified but will the same concept work with the EN500. If not would any1 happen to have the simplified version of that diagram ? I’m new too bikes and just recently picked up a 1989 454 as my first ever bike and project bike to learn and restore. No key so I’ve had to use the simplified 2 way keyed switch to get lights etc to work but cannot get bike to start. Any information or suggestions are greatly appreciated. Bike had been running then one day just stopped and was parked from previous owner. I’m believing it could b in kill switch or start button but not sure due to not knowin much about bikes. Honestly just hoping to b Able to wire bike up enough to B road legal and run. Thanks again
|
|
|
Post by dantastic on Feb 24, 2021 18:00:49 GMT -6
Does you bike have a kill switch at the kick stand as mine does? I have an '86 and when I purchased it from the original owner they let me know that the bike wont start if this pin is pushed in. It engages when the kickstand is down, and can get stuck over the years when crap gets gunked up. Try using some pliers to pull it out and lube it with some WD40. I'll try to post a pic later of exactly what I'm talking about but I'm sure some other folks can chime in on exactly what I'm talking about. Good luck and safe travels!
|
|